Are you going to use the flashing lights this Christmas? We talked to two experts on the subject.

Christmas is approaching and homes are already starting to get into the mood with various types of decorations. The traditional flashing lights are used by most people, both in their homes and in commercial establishments.

An accessory that seems to be very simple can become dangerous if it is not used in the correct way.
To avoid accidents, we talked to the electrical engineer, Ricardo Martuchi and the decorator Cecilia Dale, who told us some secrets, tips on devices and care that can help when placing the flashing light in any environment.

According to Martuchi, every care is too little and attention must be redoubled when installing flashers. "Poorly done installations or wear of the insulating material can cause current leakage, which are caused by failure in the insulation of the circuits. Many times, the circuit breaker is not enough to protect the installation, because it does not identify that there is a robbery of energy, it is necessary to pay attention to this", he tells.
He also says that the IDR, Residual Differential Switch is a device capable of detecting current leakage, avoiding excessive energy consumption or possible accidents, such as electric shock or fire, caused by sparks or heating of the circuit of small Christmas lights.

We know that lights give that finishing touch in decoration, but if you're not careful they can cause a small fire and, in a few minutes, turn into something of great proportion. In addition, if they are used in environments exposed to humidity, they can cause electric shock. "Water and electricity do not go together, it is important that people always keep this in mind", Martuchi concludes.

Christmas decoration specialist, decorator Cecilia Dale says that the first item on the Christmas tree is the placement of the lights, to prevent the wires from appearing on top of the ornaments. This also ensures that the tree is lit "inside" and gives a special effect. However, she points out that care must be taken at this time.

"Before you start assembling the pine tree, attach a line filter with a seal to the trunk of the tree. Then assemble the layer of branches at the bottom of the tree and only then place the bulbs. And never splice more than three consecutive strings of light bulbs, as you may burn them all and cause an electric short. Plug each group of three cords into one of the sockets (connections) of the line filter. Finally, don't forget to protect the floor by gluing self-adhesive felt at the foot of the tree," he explains.

‍